Pay in 4 interest-free payments of $5.00 Learn more
Ships within 48 hours · Estimated delivery Aug 11 - Aug 16
not calibration
5 - Stepper motor drivers
Printer Setup
QuickStart software
47 - 63 Hz Power requirements 24 Volts DC @ 15 Amp Power consumption 360 Watt max Software Compatible with many open-source and commercially available modeling
Belt Set Compatibility:Ultra One (MG20TB) not calibrationBecause they are kevlar reinforced, it is very rare for the belts on MakerGear 3D printers to be damaged. If your belts are worn, check your printer for alignment issuesmisalignment is the most likely cause for worn belts, and should be addressed in order to maximize the lifetime of your belts. The M2 belt set includes both belts used on the M2 and M3 SE rev 0 3D printers (630 mm for the X axis and 702 mm for the Y axis). The M3 SE belt set includes
