Bus Fault Injection Board U100 Each individual module can be

Each individual module can be networked via CANbus

TE MATEnet female to DUSB9 female cable

1 Terminal block (2-pin) Switches 4 DIP switches Dimensions (L x W x H) 108 x 82 x 33 mm Weight 185 g Operating temperature -20 to 70 °C Enclosure Aluminum profile Protection IP20 Placement Table (adhesive pads included) DIN-rail mount (see Ordering Information)

1 A 2 AIn 4 (configurable: 0 … 10VDC

symbol files

Bus Fault Injection Board U100 Each individual module can beAllows the user to inject faults into a physical layer of a differential network The board can simulate errors: a wrong termination resistor, open shorted CAN_H or CAN_L to Gnd Vdd, disconnected Gnd or Vdd or Shield signal. The fault injector board is suitable for CAN, CAN FD, FlexRay, RS 485, and LIN buses. The Board has two sides left and right. There are two D SUB9F connectors wired 1: 1 at each side. The switches for fault injection are placed