Creality Dual Extruder Silent Motherboard (Atmega V2.2/2.2.1) Ender 5 Plus CR-X PRO CR-10 V2 May be used on CR-10

May be used on CR-10 V2/V3 and CR-10S Pro/ Pro V2 if you move the Z coupler up on the motor shaft and the lead screw up in the coupler

Convenient wrench flats to simplify changing nozzles

A ground wire is included on our models and high temperature silicone over the soldered terminals (pictures do not reflect this)

For Version 1 (Nested Robots) and Version 3 (Round Logo) Shirts:

Some extra steps

Creality Dual Extruder Silent Motherboard (Atmega V2.2/2.2.1) Ender 5 Plus CR-X PRO CR-10 V2 May be used on CR-10Heatsink is installed on 5th stepper driver. Factory replacement Motherboard for Creality CR X. Ready for Firmware! Will also for work for other machines. See below. Pictures do not reflect the latest version Factory Replacement Board for the Creality CR X Upgraded 220uF C4 Cap Fixes temperature issues 2208 TMC Drivers Better holding torque and relatively quiet! Can be used to run a second extruder motor or second Z motor! Compatible with CR 10S